Install

These decals come to you in three layers. The top layer is called transfer tape. It looks somewhat like regular masking tape. The middle layer is the actual decal. The bottom layer is a backing paper treated with a release agent.
Application using the Dry Transfer Method:

Step 1 Clean Window ( or other surface ) thoroughly. Be sure to turn the cloth several times to insure thorough cleaning.

Step 2 Place graphic on desired surface and tape to the surface with masking tape across the top, creating a hinge. (Tape is not necessary for small stickers but helps for perfect placement)

Step 3 Flip graphic up and pull paper backing off, exposing adhesive

Step 4 Hold graphic tautly by the corners and flip back down so that adhesive is against surface.

Step 5 With firm pressure ( use driver license or credit card), rub graphic area from center out to edges forcing all air out. Any air bubbles will disappear.

Step 6 Wait a few minutes, then remove clear transfer tape by pulling straight back, leaving the graphic on the surface. If graphic comes of with the masking tape, repeat step 5 and wait a up to 24 hours before removing the masking tape.

Step 7 Take your fingers and check all edges and make sure they are tight. If you have an air bubble, use a pin and poke a small hole, allowing air to escape. The bubbles may disappear after a day or two

Happy with your purchase? Like us on facebook and tell all of your friends. Make sure to come back for all of your custom decal needs.
www.facebook.com/sdstickerdesigns